Develop your mobile embedded device quickly with the Fairy EDM Carrier Board which features a variety of sensors and interconnects.

Features

  • EDM Type 1 compliant
  • Display
    • 1x HDMI
    • LVDS 18/24 bit
  • 4 wire touchscreen support
  • Audio
    • SGTL5000 (I2S)
    • TLV320AIC23B (I2S)
    • 1x 3.5 mm jack Stereo Audio in
    • 1x 3.5 mm jack Stereo Audio out
    • 1x 3.5 mm jack Microphone
    • S/PDIF
    • 2W amplified speaker connectors
  • sensors
    • 3-axis sensor ST Microelectronics LIS331DLH
    • light sensor Intersil ISL29023IROZ-T7
    • compass sensor Freescale MAG3110FCR1
  • Expansion
    • 2x mini-PCIe + SIM cardslot (for 3G communication)
    • local bus
  • communication:
    • 1x Gigabit LAN
    • 2x USB 3.0 Host
    • 1x micro-USB 3.0 / 2.0 OTG
    • 2x CAN Bus on pin header
    • 1x UART (RS-232)
    • 1x UART (RS-232/422/485)
    • 2x SPI (shared with EEPROM)
    • 2x I2C (shared with EEPROM)
  • storage:
    • 1x SATA
    • 1x micro SD cardslot (SDIO)  
  • 8x GPIO (shared with buttons)
  • 12 VDC power input
  • temperature range
  • commercial : 0° to 60° C
  • extended : -20° to 70° C
  • industrial : -40° to 85° C 
  • Module Connector     314 pins MXM3
  • form factor 3.5" Form Factor
  • dimensions 147 x 102 mm (5¾ x 4 inch)

 

Available Interfaces

Order Codes

EDM1-FAIRY

  • 10,67cm (3.5'') form factor Fairy carrier board for EDM type 1 system-on-modules

 

EDM1-FAIRY-START

  • Fairy EDM type 1 evaluation board including cablekit and adaptor

 


EDM1-FAIRY-START contains the following:

  • EDM1-FAIRY Carrier Board for EDM1 modules
  • EDM-MNF-BOOT control/debug PCB Board
  • 36 Watt DC Adaptor (12V 3A)
  • DC Jack to Phoenix power convertor
  • AC cables (EU/UK/USA plug)
  • SATA data and power cable (1 set)
  • CAN bus pinheader to DB9 cables (2 pcs)
  • Serial port pinheader to DB9 cable (1 pcs)
  • USB-OTG 3.0 to USB Host cable (1 pcs)
  • Mounting poses and fastening screws (1 set)